Detail Manometer Magnehelic Hubungi : 021 44722543-085218251454
SPECIFICATIONS
Service: Air and non-combustible, compatible gases ( natural gas option available) . Note: May be used with hydrogen. Order a Buna-N diaphragm. Pressures must be less than 35 psi..
Wetted Materials: Consult factory.
Housing: Die cast aluminum case and bezel, with acrylic cover. Exterior finish is coated gray to withstand 168 hour salt spray corrosion test..
Accuracy: 2% of FS ( 3% on - 0, -100 Pa, -125 Pa, 10MM and 4% on - 00, -60 Pa, -6MM ranges) , throughout range at 70 F ( 21.1 C) .
Pressure Limits: -20 in Hg to 15 psig? ( -0.677 to 1.034 bar) ; MP option: 35 psig ( 2.41 bar) ; HP option: 80 psig ( 5.52 bar) .
Overpressure: Relief plug opens at approximately 25 psig ( 1.72 bar) , standard gages only. See Overpressure Protection Note on next page.
Temperature Limits: 20 to 140 F*
( -6.67 to 60 C) . -20 F ( -28 C) with low temperature option.
Size: 4 ( 101.6 mm) diameter dial face.
Mounting Orientation: Diaphragm in vertical position. Consult factory for other position orientations.
Process Connections: 1/ 8 female NPT duplicate high and low pressure taps - one pair side and one pair back.
Weight: 1 lb 2 oz ( 510 g) , MP & HP 2 lb 2 oz ( 963 g) .
Standard Accessories: Two 1/ 8 NPT plugs for duplicate pressure taps, two 1/ 8 pipe thread to rubber tubing adapter, and three flush mounting adapters with screws. ( Mounting and snap ring retainer substituted for three adapters in MP &
HP gage accessories.)
Agency Approval: RoHS. Note: -SP models not RoHS approved.
? For applications with high cycle rate within gage total pressure rating, next higher rating is recommended. See Medium and High pressure options at lower left......./ / /
.....
Hubungi : 021 44722543-085218251454
Tampilkan Lebih Banyak